|
|
|
|
|
首頁 >>> 產品目錄 >>> 日本竹中SEEKA/TAKEX >>> 光纖放大器
|
|
產品[日本竹中TAKEX 光纖放大器F71WPN]資料
|
如果您對該產品感興趣的話,可以
產品名稱:
日本竹中TAKEX 光纖放大器F71WPN
產品型號:
產品展商:
日本竹中TAKEX
簡單介紹
日本竹中TAKEX 光纖放大器F71WPN
電源電壓：12 - 24VDC ±10％
防護等級：IP40
全新原裝日本竹中TAKEX 光纖放大器F71WPN
|
|
日本竹中TAKEX 光纖放大器F71WPN的詳細介紹
|
|
日本竹中TAKEX 光纖放大器F71WPN
Rating/Performance/Specification
|
Power supply
|
12 - 24VDC ±10％ / Ripple 10％ or less
|
|
Current consumption
|
40 mA or less
|
|
Output mode
|
Control
output (*) : Open collector output / Rating: Source current 100 mA (30 VDC) or less / Residual voltage: 1 V or less
Stability
output (*) : Open collector output / Rating: Source current 100 mA (30 VDC) or less / Residual voltage: 1 V or less
|
|
Operation mode
|
Light ON/Dark ON selectable
|
|
Timer
|
On delay/off delay/disabled selectable (by switch)
Delay time: about 40 ms fixed
|
|
Response time
|
With switch at 4 (turbo function disabled): 250 μs or less
With switch at 8 (turbo function enabled): 500 μs or less
|
|
Light source (wavelength)
|
Blue LED (470nm)
|
|
Indicator
|
Operation indicator: orange LED / Stability (STB) indicator: green LED
|
|
Volume (VR)
|
SENS: sensitivity adjustment volume (8-turn without stopper equipped with indicator)
|
|
Switch (SW)
|
* Light ON/Dark ON selector switch: L.ON for Light ON, D.ON for Dark ON
* Timer selector switch: NOR. for ON/OFF operation, ON.D for on delay (40 ms), OFF.D for off delay (40 ms)
* Mutual Interference prevention/turbo mode selector switch (common)
8:Mutual Interference prevention for up to 8 units, turbo function enabled
4:Mutual Interference prevention for up to 4 units, turbo function disabled
|
|
Mutual Interference prevention
|
Provided
|
|
Short circuit protection
|
Provided
|
|
Material
|
Polycarbonate
|
|
Connection
|
Attached cable (outer diameter: 4.8mm) 0.2mm2, 4 cores, 2m
|
|
Weight
|
approx. 80 g (including cables and mounting bracket)
|
|
Accessory
|
Mounting bracket, screwdriver for adjustment, light shielding sticker (excluding H type), instruction manual
|
(*)Detection can start when more than 0.5 seconds has passed after power-up. If the load and this sensor use different power sources, be sure to turn on the sensor first.
(*1) The detecting distance for high-speed response H type is reduced to roughly 30% of the ordinary type.
Environmental Specification
|
Ambient light
|
Incandescent lamp: 10,000 lx max. / Sunlight: 20,000 lx max.
|
|
Ambient temperature
|
1-3 adjacent units in operation: -25 - ＋55 C
4-10 adjacent units in operation: -25 - ＋50 C
11-16 adjacent units in operation: -25 - ＋45 C
Storage: -40 - ＋70 C (non-freezing)
|
|
Ambient humidity
|
35 - 85%RH (non-condensing)
|
|
Protective structure
|
IP40
|
|
Noise
|
Power supply line: 500 V / Cycle: 10 ms / Pulse duration: 1 μs
Radiation: 1 kV / Cycle: 10 ms / Pulse duration 1 μs (with noise simulator)
|
|
Vibration
|
10 - 55 Hz / 1.5 mm double amplitude / 2 hours each in 3 direction
|
|
Shock
|
100 m/s2 / 3 times each in 3 directions
|
|
Dielectric withstanding
|
1,000 VAC for 1 minute
|
|
Insulation resistance
|
500 VDC, 20 MΩ or more
|
|
|
|
|
